Light Box Ohio State
Copyright Claim
Light Box Ohio State
Boost
21
34
9
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
3.4 h
3 plates
Boost
21
34
9
0
84
69
Released
Description
Comment & Rating (9)
All
Print Profile
0.16mm layer, 2 walls, 15% infill
Fantastic design, I just wish I had known that the AMS prints in order from left to right. I had a few small strings of the darker colors that bled into the white since it printed last. But that’s my fault, lesson learned for future prints.
The designer has replied
0
Reply
It doesn't print left to right. Change your First layer filament sequence in Bambu Studio. This will save you from shuffling filament around in the AMS just to be disappointed, learned that the hard way LOL
(Edited)
1
Reply
Thanks! And ryantrax is correct. Click the Settings button on the print plate and there is an option to set the color order.
(Edited)0
Reply
Replying to @ryantrax
First tip I found when researching said from left to right and I guess technically it was right lol. Just didn’t mention it was customizable. Thanks for the heads up!
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
The designer has replied
0
Reply
Thank you!
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld