My First attempt at doing a Hueforge, couldn't find an image that was a bit different than the rest, so generated an AI version of a stormtrooper sat in pile of destruction around him and holding his head in shame..


Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 100x100mm in size

You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.2mm

Filaments Used:
PLA+ Sunlu Black Transmission Distance: 0.6
PLA+ Sunlu Grey Transmission Distance: 2
PLA+ Sunlu Skin Transmission Distance: 5
PLA+ Sunlu White Transmission Distance: 5
This print uses 4 unique filaments

Swap Instructions:
Start with Black
At layer #9 (0.8mm) swap to Gray
At layer #17 (1.44mm) swap to yellow
At layer #19 (1.6mm) swap to White for the rest.