As the title suggests, this is a part modification for the Gamesir T4 Kaleid USB-C controller. This part replaces the current piece inside the triggers to allow for a much shorter trigger travel, similar to short stop triggers on the Xbox Elite controllers. 

This can then be configured to be a complete trigger pull using the T4 software, and allow you to have short pull triggers which is great for FPS games such as Call of Duty and XDefiant.

//Print settings

I printed this using a 0.2mm nozzle, but you could probably do it with the 0.4mm nozzle if you slowed it right down. I would recommend using PETG, although PLA also worked for me.

//Notes

Note the magnets orientation BEFORE removing it and the plastic mount, mine was indicated with a red marker on one side from the factory. It is important you insert this magnet back into the modification piece IN THE SAME ORIENTATION as it was removed. 

The original piece is held in with 3 small screws, all of which fit with the replacement piece. Be careful when putting the magnet into the mod piece, I had to support the outside of the retaining clip with my finger as it is fragile, and had a tendency to snap if not done carefully.

If you need to remove the magnet after inserting because you got the orientation mixed up - push the retaining clip over with your fingernail or tweezers CAREFULLY and use an allen key/narrow screwdriver to push the magnet from the hole in the bottom of the piece.