Beach Cup Holder
Beach Cup Holder
Boost
92
105
7
In Contest
Beach & Pool EssentialsPrint Profile(1)
no support 0.2mm layer, 2 walls, 15% infill
Designer
2.7 h
1 plate
Boost
92
105
7
5
60
24
Released
Description
Before reading the description I recommend in the future to look at the collections I created for a better service for other projects is to distinguish them better💚MAKERWORLD→ COLLECTIONS
if you like the project you want to see others so leave LIKE👍 , FOLLOW👤 AND ESPECIALLY THE BOOST 🚀
if it is very much liked we also realize the plate for the a1 mini
this Cup Holder is very convenient for the sea but also for the picnic, I recommend to print it in asa for the solo but it is fine also pla/ petg but lasts less
Comment & Rating (7)
All
Print Profile
no support 0.2mm layer, 2 walls, 15% infill
perfect print! no support version is great.
The designer has replied
0
Reply
for this I made the version nu support so it screws the lower part and saves you hours and also material🤩💪
0
Reply
Print Profile
no support 0.2mm layer, 2 walls, 15% infill
Printed well in ABS. I did have to reprint the spike at the slower “silent” speed (50%) as the 1st run at normal speed made the spike fall over when starting the screw section at the top. When finished, though, the spike fits perfect into the cupholder.
0
Reply
Boosted
gooodddd
1
Reply
Boosted
I will test tomorrow and let you know xD Very good idea!
0
Reply
Print Profile
no support 0.2mm layer, 2 walls, 15% infill
0
Reply
Boosted
Print Profile
no support 0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld