This is a completely modular, stackable dispenser for 12oz energy drink cans – cans that are 6.125 in tall, and have a diameter of 2.25 in.

There are four layer center lengths(L, M, S, and Tiny), and you can mix and match as you please – if you're stacking, it's a good idea to start with the largest layers at the bottom.

Each layer needs at least one of the three end caps:

• Input: This is where you'll load your cans.
• Catch: When stacking multiple layers, use this end cap to catch cans that roll down from the above layer.
• Output: This is where you'll pick up your cans.

When stacking layers of different lengths, align the dovetail joints on the side with the catch endcap.

Plate Descriptions:

1. Right Large Center: Right half of a large center.
2. Left Large Center: Left half of a large center.
3. Large Top (Optional): If the top of your stack has a large center, you can print this top to make it more aesthetically pleasing. The top also provides some rigidity.
4. Medium Center: Both sides of a medium center.
5. Medium Top (Optional): If the top of your stack has a medium center, you can print this top to make it more aesthetically pleasing. The top also provides some rigidity.
6. Small Centers: Both sides of a small center.
7. Small Top (Optional): If the top of your stack has a small center, you can print this top to make it more aesthetically pleasing. The top also provides some rigidity.
8. Tiny Center: Both sides of a tiny center.
9. Tiny Top (Optional): If the top of your stack has a tiny center, you can print this top to make it more aesthetically pleasing. The top also provides some rigidity.
10. Input End cap: Both sides of the Input end cap.
11. Catch End cap: Both sides of the Catch end cap.
12. Output End cap: Both sides of the Output end cap.
13. Dowels: There is a 25mm and 30mm dowel on this plate. Clone as many as you need accordingly:
    1. Large, Medium, and Small centers require two 30mm dowels each.
    2. Tiny centers require one 30mm dowel.
    3. Endcaps require one 30mm dowel and two 25mm dowels each.
14. Empty End cap Cover (Optional): If you have multiple layers, you can place this end cap hole cover on the side where the cans roll down to the next layer. This makes the center more aesthetically pleasing, but adds some rigidity.
15. TPU Socks (Optional): You can place these TPU socks on the bottom layer to add some traction, if desired.