🖱️ A modular mouse compatible with the Bambu Lab Wireless Mouse Components Kit 002.

🧩 20 parts to mix and match to create your perfect mouse.

📏 Easy to remix to create your own mods!

Assembly Instructions

1. 3D print the parts you want. If you're unsure, try the Starter Pack print profile.
2. Insert the on/off switch and lens into the base.
3. Insert the scrollwheel into the mouse PCB, then insert the PCB into the base.
   1. Ensure the on/off switch and lens are positioned correctly.
4. Place the battery connectors into their slots in the base, then connect the cable to the PCB.
5. Insert a AA battery, then screw the battery cover on using an included screw.
   1. Ensure no wires are being pinched.
6. Assemble your mods by sliding them together.
   1. Ensure the slots/rails are free from support material. You may also need to clean up the edges to ensure parts fit together smoothly.
   2. Due to differences in 3D printers and filament, your parts may be too tight. You can try sanding the rails to make them fit. Alternatively, try 3D printing again with adjusted settings.
7. Place your mods on top of the base, then secure them using the included screws.
8. Attach adhesive feet to the bottom of the mouse.
9. You're done!
10. If you want to change things up, simply unscrew the base and mix+match your mods!

Included Files

Base		The base component to insert the PCB into.	Regular
Buttons			Regular Raised
Palm			Regular Raised
Wrist			Short Medium Long Large Curved Extended DIY
Thumb		ℹ️ All thumb parts are for the left side of the mouse. Mirror the parts for use on the right side.	Short Regular Large DIY
Hat		An optional decorative piece on top.	Basic DIY
Other		Use these parts to extend or create your own mods. DIY parts are also included for the thumb, wrist, and hat parts.	Extension Rail