Had to print it a few times, just be careful when screwing it in cause it could break.

10/10

Nice model, got to dig up some screws now. Ps. I just mirrored the file 😉

screw covers are to thin

Really cool idea, thank you for this! I would have a few suggestions for improvement, the first three really simple and the last two a bit more advanced: 1. Flip the covers on the build plate, that way you avoid the overhang and bridging issues 2. Slightly increase the 5mm hole diameter as 3D Printers tend to print holes a little bit smaller than designed. 3. There is no need for two different caps. Just extend the bottom of the lower hole to match the upper one. Reduces complexity a bit. 4. Add a finding feature (e.g. groove and tongue) so that the hanger stays flush when extended 5. Chamfer the edges to get a much more refined look. Unfortunately the Standard Digital File License does not allow for remixes, otherwise I would share the modifications I did for myself. Great work anyway!

très utile

Abdeckkappen sind etwas zu lose, sodass sie rausfallen. Dafür sind die Löcher der „Unterlagscheibe“ und der zweiten Bohrung etwas zu eng für die Schrauben.

The print works well.