Search models, users, collections, and posts
Quad Fidget
IP Report
Print Profile(2)
0.2mm layer, 3 walls, 10% infill
Designer
45 min
1 plate
0.2mm layer, 3 walls, 10% infill
Designer
2.4 h
1 plate
Open in Bambu Studio
Boost
8
8
2
1
18
12
Released
Description
Fidget spinner with 4 ways to fidget! Your carpal tunnel is not my fault.
Update 6/25:
The removable ring will work with this fidget now → Fidget Karambit by richard.gurley - MakerWorld
The new body and ring are not backwards compatible; however, the gear and gear ring should be compatible with previous prints.
The profile is for PLA and objects are oriented in the correct position.
IMPORTANT: THERE IS A SMALL INDENT ON THE UNDERSIDE OF THE GEAR. THIS INDICATES THE SIDE THAT SHOULD FACE THE BODY. IF YOU SEE THE INDENT AFTER PRINTING, YOU'RE DOING IT WRONG :)
Check out my other fidget! Fidget Karambit by richard.gurley - MakerWorld
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)