This is a special release in my “pet planters” project. I took a different direction with this one and created a “pokemon planter” feature Eevee!

This is a completely different design than my original planters. I simplified and drastically reduce the amount of plates needed. There is 2 ways to print this. You can print one that allows the head and tail to be attached via 8X2mm magnets. This makes the planter completely customizable as you can easily swap out the tail and head. I also plan on release special holiday themed version of the different pets over time.

You can also print the base that allows the head and tail to be glued on. This one is obviously permanent and not customizable but it also doesn't require anything else aside from glue.

The head and tail work for either base so there is only one version of those.

The legs simply slide into the base and in my experience the fit is tight enough that I didn't need to use glue to hold them in place. I do recommend printing the legs with at least 25% so that they are sturdy.

Everything can technically be printed without supports. However, I DO recommend using supports for the head as the magnets snap in much easily when supports are used. I also used supports for the body as well as it allows the legs to slide in easily as well. The supports are very minimal and if using my print profile they were super easy to remove. That being said, I did print several versions without supports and they work fine the legs and magnets just don't fit in as “smooth” as when using supports.

Here's a link to the 8X2MM magnets I use: https://www.amazon.com/gp/product/B08C4SQSM3/

If there's enough request for additional magnet sizes then I can make that happen.

Happy printing!

See the rest of my pet planter collection here: https://makerworld.com/en/@3DSportsBeard/collections/1387799
Commercial license available here: https://www.patreon.com/The3DSportsBeard
Appreciate my designs? Buy me a beer: https://buymeacoffee.com/the3dsportz