This is a design by me, transformed into a filamentpainting using Hueforge.
If you scale it, dot change the height of the image
You don't need a AMS to print this, but it makes it alot easier
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.24mm
Filaments Used:
PLA+ Sunlu Black Transmission Distance: 0.6
PLA+ Sunlu Grey Transmission Distance: 2
PLA+ Sunlu Red Transmission Distance: 6
PLA+ IIID Max Yellow Transmission Distance: 8.5
Swap Instructions:
Start with Black
At layer #6 (0.64mm) swap to Grey
At layer #9 (0.88mm) swap to Red
At layer #12 (1.12mm) swap to Yellow for the rest.