Search models, users, collections, and posts
Side Storage Box
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.8 h
1 plate
Open in Bambu Studio
Boost
3
7
0
2
4
1
Released
Description
Content has been automatically translated.
Boost Me (for free)
If the model helps you, please support me! Thank you!
Used for storing on the side of assembly parts boxes purchased on Taobao. I usually put glue in it, which is convenient to hold. The storage box model is "New F3: 205*135*78". Other models of assembly boxes can first try printing the clips to check the size. You can adjust the length of the clips slightly to make them fit.>
If the clips are a bit tight when installing, you can use a craft knife to trim the four small protrusions on the corners a little bit, and it should be fine.>
Accessories used:>
Knurled nuts: M3*5 height*4, 4 pieces>
M3 screws: M3*5 or M3*6, both work, 4 pieces>
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)