Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size. You can adjust the X and Y but Z must remain the same.
You may print at higher layer heights below the Min Depth of 0.48mm
Actual Depth is 2.3mm

Filaments Used:
BambuLab Basic Black Transmission Distance: 0.3
BambuLab Basic Blue Gray Transmission Distance: 2.5
BambuLab Basic Gray Transmission Distance: 3
BambuLab Basic White Transmission Distance: 6
This print uses 4 unique filaments but you can substitute as needed.

Swap Instructions:
Start with Black
At layer #8 (0.72mm) swap to Blue Gray
At layer #13 (1.12mm) swap to Gray
At layer #19 (1.6mm) swap to White for the rest.