Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size. You may adjust the X and Y but Z must remain the same.
You may print at higher layer heights below the Min Depth of 0.48mm
Actual Depth is 2.3mm

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.3
PLA BambuLab Basic Beige Transmission Distance: 8
PLA BambuLab Basic Brown Transmission Distance: 2
PLA BambuLab Basic White Transmission Distance: 6
This print uses 4 unique filaments. You can substitute as needed.

Swap Instructions:
Start with Black
At layer #8 (0.72mm) swap to Beige
At layer #12 (1.04mm) swap to Brown
At layer #14 (1.2mm) swap to White for the rest.