Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 100x100mm in size. You can adjust the X and Y but Z must remain the same.
You may print at higher layer heights below the Min Depth of 0.48mm
Actual Depth is 2.1mm

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.3
PLA BambuLab Basic Blue Gray Transmission Distance: 2.5
PLA BambuLab Basic Gray Transmission Distance: 3
PLA BambuLab Basic White Transmission Distance: 6
This print uses 4 unique filaments. Substitute to your own needs.

Swap Instructions:
Start with Black
At layer #9 (0.8mm) swap to Blue Gray
At layer #16 (1.36mm) swap to Gray
At layer #20 (1.68mm) swap to White for the rest.