The Fifth Element Movie Poster Fridge Magnet
Boost
15
9
7
Print Profile(1)
0.08mm layer, 2 walls, 15% infill
Designer
4.3 h
1 plate
Boost
15
9
7
3
8
2
Released
Description
The Fifth Element movie poster fridge magnet.
Measuring 66mm wide by 96mm high by 5mm deep
This model requires 2 x AMS units to print
8 colour Bambu AMS print, using Red, Lemon Yellow, Orange, Beige, Black, White, Blue and Ice Blue
This needs 4x 8mm diameter by 2mm deep magnets, the magnets push into the model after printing, no need to pause.
NOTE - The magnets are designed to be a tight fit. The best way to insert them is to line up a magnet with a hole then place the model on a hard flat surface facing up, with the magnet on the hard surface, then press down firmly on the model. The magnet will snap into place. Repeat for each magnet.
Comment & Rating (7)
All
this would be awesome as a hueforge
The designer has replied
0
Reply
It is a hueforge... Just a small one with a built in frame
0
Reply
Replying to @crabstiks
I get that but the built in frame makes it impossible to print with one ams or even without ams, and its tiny lol. what if i wanted it bigger and in a frame of my choice i cant do that.
1
Reply
Boosted
you are great
The designer has replied
1
Reply
Wow thank you! That's really kind of you to say! And thank you for the boost too! It's much appreciated
0
Reply
For the A1 and Mini, can you please tell us what layer to pause at, and what colors to replace with what colors?
The designer has replied
0
Reply
I'm sorry but this one needs 2 AMS units. It's not always possible to use a pause. It's to do with the depth I have to work within to keep all the models the same depth.
If a model has a pause I always upload a print profile with the pause built in and mention it in the instructions
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld