New Version that fit all Babyphone Cameras with a standard Camera Thread 1/4-20 UNC

Easy to print, no supports, all bolts printable

Idea

Newly made dad who didn't feel like spending money again for a simple holder and also didn't wanted to drill holes in the wall.

I made the first version specific for the Momcozy Setup, but didn't like that you saw a bolt in the view.

This new version don't has this problem anymore and is compatible to many more Cameras that have the 1/4-20 UNC Thread. 

I modeled a Hirth Joint between the camera platform and the base with 20 clicks to adapt the angle.

The parts

• Clamp base
• Base top
• Camera platform
• 1x big 20mm bolt, easy turn-able with your hand
• 1x 6mm bolt to connect base with top
• 1x 10mm bolt with handle to adjust camera angle
• 1x 1/4-20 UNC camera bolt

How to assemble?

• Verify if the bolt holes don't have small filament pieces, if so, remove them with a cutting tool
• Check all bolts before assemble in there holes, sometimes you need to turn them back and forth a bit (i removed between 0,05-0,1 mm on all bolt threads - needed when you 3d print bolts)
• Connect base top to the base with the 6mm bolt - 5mm Allen Key needed (the 6mm is longer than the 1/4-20 UNC bolt)
• Screw the 20mm bolt in the base
• Connect you camera to the platform with the 1/4-20 UNC camera bolt - 5mm Allen Key needed
• Now connect platform to top base with the 10mm bolt with handle
• Tight all bolts Carefully, no need over tighten. 

What do you need?

• Parts and bolts should be printed with different settings. Bolts need to be stronger

Printing instructions

I printed all on an Creality K1

Filament i used is Creality PLA+ White

Certainly you can use your own filament with your settings. The table below are my setting which give me good results for the bolts.