7-Day Pill Donut with Reminder Slot
Remixed by
Copyright Claim
7-Day Pill Donut with Reminder Slot
Remixed by
Boost
3
8
7
Print Profile(1)
0.2mm layer, 4 walls, 5% infill
Designer
1.3 h
1 plate
Boost
3
8
7
0
40
38
Released
Description
Why spend dollars on a pill container when a few cents of filament can manage the same thing? Well because most of the other pill containers either have a full slide off lid, too many slots, and it was tough finding something similar enough to the easy to use commercial versions.
Then I found the Pill Box Donut by Heapstar and it was near perfect, it just didn't have labels for the days. That's when I noticed it had 8 slots, and that 8th slot would be perfect for a “REFILL” reminder.
I hope you all find this as useful as my lady has!
Comment & Rating (7)
All
Print Profile
0.2mm layer, 4 walls, 5% infill
honestly, as designed you’re gonna get maybe two pills into this. I scaled the z axis 500%, which then made the caddy 50mm tall. I’m not sure who is finding use from an original 10mm high pull caddy but more power to you if you do.
(Edited)0
Reply
Print Profile
0.2mm layer, 4 walls, 5% infill
Little loose, did not snug down nicely allowing for about 3 mm upward movement which allows the top to spin in both directions.
0
Reply
Print Profile
0.2mm layer, 4 walls, 5% infill
best one yet
0
Reply
Print Profile
0.2mm layer, 4 walls, 5% infill
nicht so gut.
Deckel fliegt weg und deutlich zu klein
0
Reply
Print Profile
0.2mm layer, 4 walls, 5% infill
0
Reply
Print Profile
0.2mm layer, 4 walls, 5% infill
0
Reply
Print Profile
0.2mm layer, 4 walls, 5% infill
0
Reply
No more
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld