My kid is in a wheelchair for a couple of weeks, but the handles to push her around are just a little to low for me.

So I created these extension pieces to have a more comfortable position when walking arround a bit longer :-).

I printed these with Bambu Lab PLA at:

• 0.2mm layerheight
• 5 walls
• 10 Top&Bottom layers (to have about 2mm thick shell everywhere)
• 40% triangle infill.

I used “slower” print settings (80-160mm/s) (just to have a cleaner finish).

For mounting I used:

• 4x M5x40mm bolt
• 4x M5x30 bolt
• 8x M5 nut
• 8x M5 rounds or washers.

Enjoy.