I created this plate to fit in the Cybertruck wireless phone charging tray. I always use a phone mount so this space just gets used to hold things other than a phone, at least on the drivers side. So I created this plate to hold my glasses and a pen, chapstick or a pack of gum and uploaded a separate file with separations.

However, this upload is blank version of the plate in case you want to customize it. I would love to see some useful remixes!

This fits incredibly well! I didnt measure any angles, it was all done by eye and a few failed attempts. This should slide into place very well and kind of clamp on at the top back. If you want to pull it out, just pull the back of the top piece away from you and it pulls right out.

This version does NOT need supports. I printed in PETG for the higher temp of the interior of the car.

*** I am also uploaded the same piece but WITH separations that work well for glasses, business cards, etc… Click on my profile and look for "Cybertruck Phone Charger plate with separations" if you want to check it out. Ignore the thin rectangular artifact on the left part of the face, if you see it at all. It should not be visible when you print. It wasnt on mine.

If you like it, please give it a thumbs up and PLEASE REMIX! Thanks and enjoy!