Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size. You can increase the X and Y but Z must remain the same.

You may print at higher layer heights below the Min Depth of 0.48mm
Actual Depth is 2.2mm

Filaments Used:
BambuLab Basic Black Transmission Distance: 0.3
BambuLab Basic Blue Gray Transmission Distance: 2.5
BambuLab Basic Gray Transmission Distance: 3
BambuLab Basic White Transmission Distance: 6
This print uses 4 unique filaments. You may substitute as needed.

Swap Instructions:
Start with Black
At layer #7 (0.64mm) swap to Gray
At layer #12 (1.04mm) swap to Gray
At layer #17 (1.44mm) swap to White for the rest.