Tired of the seatbelt on the BMW Z4 (G29 2019-2024) being way too high and cutting into the neck. This mod keeps the seatbelt at the proper height. Printed in PTEG for flexibility with just little support (printed laying on it's side.

NOTE: Relocating the seatbelt might be a safety risk and I do not take any responsibility for failure or risks associated with injuries during accidents. Installation at your own risk!

Installation:

Remove the original holder (2 screws, one on top at the magnet, the other below under the small cover)

Remove the leather strap and insert the new 3D printer holder into the opening. It is a very tight fit, some pressure is required.

Re-install the cover with the original screws (without the leather strap) and insert the seatbelt…done!