Portable Phone stand with key ring by Mr.Fusible

Mr.Fusible

3D Printer>3D Printer Accessories

Print Profile(1)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 3 walls, 20% Gyroid infill

Designer

27 min

1 plate

4.3(13)

Open in Bambu Studio

Boost

Released

Description

Print in place, Portable Phone stand.

A small and lightweight portable phone stand. Add it to your key ring, lanyard or backpack for on the go show watching :) Print in place hinge for adjustible viewing angles. Simply open wider for less tilt, and closer for more tilt. ENJOY!

Details:

Small, Sturdy, adjustible
No supports required
Uses less than 8 grams of filament. Perfect for those left over spools
Prints in less than 25 minutes.

Comment & Rating (25)

@user_411169205

Print Profile

0.2mm layer, 3 walls, 20% Gyroid infill

turned out perfect 👍

(Edited)

The designer has replied

@Mr.Fusible

Fantastic! Thanks!

@xeni

Print Profile

0.2mm layer, 3 walls, 20% Gyroid infill

Good print, holds the phone well, quick and easy :)

The designer has replied

@Mr.Fusible

Nice! Glad you like it. :)

@Saurainne

Print Profile

0.2mm layer, 3 walls, 20% Gyroid infill

useful thanks bro

(Edited)

The designer has replied

@Mr.Fusible

Thank you!

@Liquidretro

Tried printing in a generic PLA on my X1C and the tolerances were too tight with either slicing method and it couldn't move.

The designer has replied

@Mr.Fusible

Try adjusting the tolerance both to 0.0008 within your slicer. the profile was sliced with that due to the super tight tolerance when I designed it.

@ThisGuy

Replying to @Mr.Fusible :

I am experiencing the same, what do you mean by "adjusting the tolerance"?

@Mr.Fusible

Replying to @ThisGuy :

I went ahead and adjusted the models tolerances, so the updated version as of last week should fix that issue. it’s odd, but it doesn’t seem to be an issue for most. it’s possible that the issue could be filament based. anyhow, within the slicer, you’ll find “resolution” and “slice gap radius” you can try setting those to 0.0008. tolerance was the wrong explanation, my fault.

(Edited)