A soap dispenser plug so you can refill your Dispenser and not trough if away.

Its made for a specifix soap Dispenser from Sagrotan. What you need it a drill and you need to drill two holes for the Plug. One is 6mm diamtere and one 12mm. The space between the middle of one and the other hole is 25mm. i drilled the first hole 25mm away from the center and then driller the bigger (12mm) hole in the middle of the container.

I would suggest printing it in TPU because it will stay flexible and use 99 Walls or 100% Infill because it doesn't really matter the infill because the object is small so the printing time and Filament is not that much used.

For this object no supports are needed as the angles of the object are always so that a Bambu lab printer can print it without support.

Please calibrate your TPU before printing this and mine printed fine at about 50mm2.