UofM lightbox
Copyright Claim
UofM lightbox
Boost
26
32
9
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
28.8 h
2 plates
Boost
26
32
9
0
33
26
Released
Description
U of M Lightbox.
Comment & Rating (9)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
If you have a cool plate, I highly suggest printing the parts on the face. Cuts the time down tremendously. Great file! Great print!
The designer has replied
1
Reply
Thanks for the feedback! I love the lighting you used!
(Edited)1
Reply
Replying to @Chuck85ap
Thanks! Here's the link.
Smacen Battery Powered COB Led... https://www.amazon.com/dp/B0BGCJ6QWK?ref=ppx_pop_mob_ap_share
0
Reply
I printed the front of the light box flat on its face on a cool plate. Took only 3 hours and turned out wonderfully! The back plate took 1 h 30 mins. Great print! Used SUNLU PLA+ in Blue Gray and Yellow. 126.94g for first plate. 61.81g for the second. I used a battery powered COB LED light strip adhered to the inside edge. Turned out great!
0
Reply
really over 600 grams for the first plate why?
The designer has replied
0
Reply
My total shows 127 grams total. I would look into your settings.
(Edited)1
Reply
I am not sure how you’re getting 600 grams.
0
Reply
Would love to see a single layer of white PLA on the back side for better light diffusion!
Great work on the light box, I like the thicker outline.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld