Deer Voronoi no support Remixed by SabreDesign

Remixed by

SabreDesign

Household>Festivities

Print Profile(8)

All

X1 Carbon

P1S

P1P

X1E

A1 mini

Vonoroi 0.16mm layer, brim, no support

Designer

3 h

1 plate

4.7(269)

Voronoi 0.2mm layer, brim, no supports

Designer

2.4 h

1 plate

4.7(70)

Solid 0.16mm layer, brim, no support

Designer

1.6 h

1 plate

4.6(48)

Solid 0.2mm layer, brim, no support

Designer

1.4 h

1 plate

4.4(34)

Click to see more

Open in Bambu Studio

Boost

782

1618

469

3.5 k

Released

Description

Christmas Deer models, Approximately 165 mm tall and 100mm wide.
Best printed in PLA with brim no support needed, set auxiliary part cooling fan to 100%

Remixed custom scaled models for optimal printing size, also patched the holes in the voronoi mesh and oriented for optimal printing on the bambu machines.

All credits for the original models go to the designers:
https://www.thingiverse.com/thing:571949
https://www.thingiverse.com/thing:3320230

If you want to support me or get a commercial license you can join a patreon membership: https://www.patreon.com/SabreDesign

Comment & Rating (469)

@PeterHall

Print Profile

Vonoroi 0.16mm layer, brim, no support

Thank you for this beautiful model. I am so impressed with what this printer can do.

(Edited)

@Jetranger61

I tried this model. Great success with Bambu Blue PLA but total failure,twice,using Polar White.Gets to the head just prior to starting the antlers and the whole thing moves on the PEI textured plate.What can I do to improve success rate? 0.16 layer,brim,no support.

@taisen20

Replying to @Jetranger61 :

Same for me. Hard to print

@nynerds

The fam!

(Edited)

@user_1070349731

what did you spray on the antlers?

@Deathbyphone

Print Profile

Solid 0.16mm layer, brim, no support

Turned out good. One of the back legs messed up but that was my fault. Will definitely make some more.

@janse

I am having the same issue over and over again. did you find a solution?

@Deathbyphone

Replying to @janse :

I haven’t reprinted yet, but I believe my issue was bed adhesion. The back leg popped off the plate a little. I had made a lot of prints without cleaning off the bed. It happened on another print that I was doing and I cleaned off the bed and it fixed the issue.