Gingerbread house decorated with icing, peppermint candies, candy canes, a chocolate bar and gumdrops.

Designed to be a good size for a tabletop or desk decoration. Approximate Size: 95mm tall with a 118mm x 136mm Base

This contains numerous models, some of which will need to be printed more than once:

• Base - 1x (choose one of the options available)
• Side Wall - 2x
• Front Wall - 1x
• Back Wall - 1x
• Roof - 2x
• Gumdrop - 9x
• Candy Cane Red - 2x
• Candy Cane White - 2x
• Peppermint Red - 2x
• Peppermint White - 2x
• Chocolate Bar - 1x

Check out the rest of my Christmas models here!

Print Settings

3 pieces will require a color change from brown to white for the icing - both roof pieces and the front wall.

I recommend using a brim for the candy cane pieces.

Assembly Instructions

This model is designed to be glued together to replicated a real gingerbread house. It is easy enough to assembly that it can be a family activity. I recommend using 3D Gloop instead of super glue. It will allow for a little longer working time.

• Glue together the candy cane and peppermint candy pieces
• Attach walls together
  • I used the base as a guide. Place the walls into the base and glue the walls together, one by one. Once all are dry, use glue to permanently attach them to the base.
  • Be sure that the side walls stick up past the front and back walls (shown below). Also ensure that the side walls tilt slightly outward. They should be flush with the sides of the front and back walls. (Dry fit first to ensure a good fit)

• Attach peppermint candies - flat side attaches to the front and back panels.
• Attach candy canes to the side walls - ensure that the top of the candy canes share the same angle as the slope of the side wall tops.

• Attach the roof pieces to the walls - the side walls should slot into the holes on the bottom side of the roof panels.

• Add gumdrops and the chocolate bar to the base.

Buy Me A Coffee

The following filaments were used in the pictures above:

Gumdrops

• polymaker PolyTerra Lava Red PLA
• polymaker PolyTerra Forest Green PLA
• polymaker PolyTerra Banana Yellow PLA

Candy Canes and Peppermint Candies

• Sunlu White PLA
• polymaker PolyTerra Lava Red PLA

Chocolate Bar

• Hatchbox Brown PLA

House Walls/Roof

• Duramic Brown PLA+
• Sunlu White PLA

Base

• Sunlu White PLA
• polymaker PolyTerra Cotton PLA