This is an updated asian hornet trap, inspired by the usual design for the cone but with more perks, as:

• Support beams, to allow better angle when attach to branches and placement on ground
• Better and way more resistant pot thread, with thread stop at end
• More gripping outside knurling

The main profile uses 0.6 nozzle, to allow faster print.

Note: I've seen a lot of the “usual design” sold on the French site “le bon coin”, despite it being none-commercial,

I WILL react if you try to sell my design on this platform, since It's my primary source of sales

If you want to sell these traps, and you are not near Geneva, then don't hesitate to contact me, so I can license you the design.

(If you are a non-profit, still contact me, but I will probably allow the use of the design freely)