This is a airbrush cleaning pot lid for a glass jar 

My design will be good for a jar that has 85mm lid with tab in slot type of thread where there are 6 tabs distributed evenly around a circumference and they ride under the 6 threads on the jar lid.

Lid has 2 holes:
-Big one is for air brush
-Small one can be blocked with a foam rubber to hold small water particles.

Infill 50% is recommended

If you have any questions about the lid, please feel free to write me a message.

Thank you and if you would like to leave a comment or feedback, please feel free to do so in the comments section.

Have a nice day and good printing!