Aeropress Filters Case
Copyright Claim
Aeropress Filters Case
Boost
3
1
1
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
1.6 h
1 plate
Open in Bambu Studio
Boost
3
1
1
0
2
3
Released
Description
Just a simple aeropress filters case for some travels or for home.
Case is twist closed with a one turn thread. It is recommended to print with low layer height (around 0.16-0.2) so thread will not break apart while printing.
Feel free to use PET-G but i used PLA and it works perfectly fine.
Comment & Rating (1)
All
Print Profile
0.16mm layer, 2 walls, 15% infill
To accomodate the Aeropress XL filter I increased the print by 14%. Resulted in a perfect fit.
Only thing I would like to adjust for a future print is aligment of the lettering on the front and back.
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld