Sprue/ Runner Holder for Ikea SKÅDIS Pegboard
Copyright Claim
Sprue/ Runner Holder for Ikea SKÅDIS Pegboard
Boost
0
2
2
Print Profile(2)
(6 Slots) 0.2mm layer, 2 walls, 15% infill
Designer
28 min
1 plate
(Single Slot) 0.2mm layer, 2 walls, 15% infill
Designer
12 min
1 plate
Open in Bambu Studio
Boost
0
2
2
1
5
2
Released
Description
Sprue/ Runner Holder for building Gunpla, 30MM, 30MS, or other plastic model kits. I included the 6 slot version and 1 slot versions. These require no supports and you do not need to apply much force when adding or removing your runners. Have built a few kits using this holder to test it's durability and it is holding up very well.
Inspired by this model: https://makerworld.com/en/models/247895#profileId-302849
Comment & Rating (2)
All
Boosted
the hook on the skadis board was on my print a little bit loose, but it is holding the sprue fine :).
The designer has replied
1
Reply
I'm glad its holding the sprue ok! Sometimes I had to put a little force on it to push the hook all the way in place.
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld