螺旋杯子！
Copyright Claim
螺旋杯子！
Boost
50
51
6
Print Profile(1)
0.15mm layer, 2 walls, 15% infill
Designer
6 h
1 plate
Open in Bambu Studio
Boost
50
51
6
0
132
23
Released
Description
趣味的功能工艺品！
Comment & Rating (6)
All
NO!!!
0
Reply
Why no?
0
Reply
宝宝奶昔！！！
1
Reply
Print Profile
0.15mm layer, 2 walls, 15% infill
The print-profile is ok, but the model is kinda unusable. Due to the small inner-diameter of the straw you need a lot of negative pressure to get fluids sucked up. On top there are to much windings which leads to a long journey for the fluid. You start to sweat before you get to the water. ^^
Don't get me wrong, the idea behind it is great, but at the moment I would only recommend it as an eye-catcher (which it really is!), not for real use.
I printed it with Bambu PETGand had no issues!
0
Reply
Print Profile
0.15mm layer, 2 walls, 15% infill
Dont works good!
0
Reply
Print Profile
0.15mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld