AMS Filament feeder tube protector
Copyright Claim
AMS Filament feeder tube protector
Boost
3
12
7
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
15 min
1 plate
Boost
3
12
7
0
27
42
Released
Description
This nifty addition not only reduces the wear caused by materials rubbing against the tube but also significantly cuts down the occurrences of the AMS motor overload error. 🚫
Why go through the hassle of replacing the hard-to-reach and complex filament feeder tube when you can easily swap out this simple, small cap once it shows some wear? It's a quality-of-life hack that makes a world of difference. 🛠️
Comment & Rating (7)
All
I printed as presented in PETG. Install is easy once you figure out how. You have to seat them at the rear with the rear down, then kind of roll it forward and down and they snap into place. I installed them on both of my AMSs, and am printing spares. Thanks!
(Edited)0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
these were too small for my p1s
0
Reply
Not sure if it's just me, a user error problem, but this doesn't have a great fit. Maybe I'm missing an obviously better way to put them on.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Other Issues:they pop off when filament gets pushed back out of the AMS onto the roll
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld