Hello everyone... here I have an adaptation for you for Black Crow's Rc trailer so that Stepan Müller's Ragnarok Jet Sprint boat fits on it

The middle supports need to be replaced so that the supports can be screwed on in the middle

of screws used are

12x m3x20
6xm3x30
4x m2x12-16

For 16mm it is best to secure with M2 nuts

There are no holes provided for the bracket on the bow, you have to pre-drill them with an M2 drill... but it's up to you whether you install it... it's not necessary in itself

I uploaded the large carriers three times. However, you can also just load one and duplicate it if they are all the same.

However, I put the carrier together so that it fits on a large print bed. If you have a small bed you have to split it in the middle, there is a hole for a screw.