This sink is a remix of newcrz's cooling sink designed to not be obligated to pass the filament through any hole during the extrusion process. Two models are available with different heights depending on your preference. This sink also include two evacuation holes instead of one to favorize water evacuation and allow you to use higher water flow. The evacuation holes are also placed lower to minimize stagnant water after use.
Should be printed with 0.4mm wide layers (wall thickness is calculated to be 4 layers) with high extrusion flow to insure that the sink is water tight. No support required.
Printer Brand:
FlashForge
Printer:
Adventurer 3
Rafts:
No
Supports:
No
Resolution:
200
Infill:
20% Triangle
Black