clock - rotating number dial - kit 011 by RetroSharky

RetroSharky

Hobby & DIY>Electronics

Print Profile(2)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

0.16mm layer, 2 walls, 15% infill

Designer

51 min

1 plate

5.0(3)

0.16mm layer, 2 walls, 15% infill

2.5 h

1 plate

Open in Bambu Studio

Boost

Released

Description

Clock - rotating number dial - Components Kit 011

I found the set uninteresting with standard hands. So instead of rotating the hands, the numbers are moved. The time is shown on the left. A coloured insert illustrates this further. All parts are designed separately and can therefore also be printed in colour without AMS.

The following set is required: https://eu.store.bambulab.com/collections/makers-supply/products/clock-components-kit-011

What is needed from the set: Clock, second hand, washer and nut
What is not needed from the set: Hour hand, minute hand, rubber spacer ring
What else is needed: File or knife for the holes

Important: Do not install the rubber spacer ring. When assembling, make sure that the numbers are inserted exactly as shown, otherwise you will never be able to set the time correctly. The holes in the discs are deliberately a little too small, the discs have to fit tightly. It is recommended to finish them very carefully with a file or knife.

clock

clock components kit 011

Bill of Materials

Bambu parts

Clock Components Kit (1pcs)-011

MH011

× 1

Purchase from Bambu Store

Comment & Rating (14)

@mrthet

Really nice design. Is there any way to change the 60 on the minute hand into a 00?

The designer has replied

@RetroSharky

Unfortunately I can't upload the original Fusion CAD file here because it is in the cloud. So I would do it this way: Either cut away the 6 in Bambu slicer or in Meshmixer and insert a copy of 0 next to it. That would probably be the easiest and quickest. Alternatively, you can use the font tool and simply enter a zero, but you still have to cut away the 6 first.

@mrthet

I'll give that a try, thanks.

@thisnoise

Boosted

This is really nice :)

The designer has replied

@RetroSharky

Many thanks for the boost. That was the first one I received. Thank you very much. :)

@thisnoise

Boosted

Replying to @RetroSharky :

You're welcome. Happy designing :)

@jojokeat

trying to figure out how one reads this? I love the design I had an idea for something similar and found yours looking to see if it existed. would you read where the extra hand was or the horizontal section?

The designer has replied

@RetroSharky

Take a look at the large picture in the description: There you can also see that there is a coloured insert. The numbers floating above show the time. The idea is not really new, but is based on old "rotating dial watches". You can also search for the term on google. Beside, the time can only be read on the left, otherwise the digits are upside down. Due to the design of the movement, it is not possible to read the time on the right side. What you probably see as the "extra hand" is the second hand? It works normally.