Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size. You can adjust the X and Y but the Z must remain the same.
You may print at higher layer heights below the Min Depth of 0.48mm
Actual Depth is 2.2mm

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.3
PLA BambuLab Matte Ash Gray Transmission Distance: 1.5
PLA BambuLab Basic Purple Transmission Distance: 2.6
PLA BambuLab Basic Green Transmission Distance: 2
PLA BambuLab Matte Marine Blue Transmission Distance: 0.5
PLA BambuLab Matte Mandarin Orange Transmission Distance: 3
PLA BambuLab Matte Ice Blue Transmission Distance: 3.5
This print uses 7 unique filaments. Substitute to suit your needs.

Swap Instructions:
Start with Black
At layer #7 (0.64mm) swap to Ash Gray
At layer #9 (0.8mm) swap to Purple
At layer #12 (1.04mm) swap to BambuLab Green
At layer #15 (1.28mm) swap to Marine Blue
At layer #21 (1.76mm) swap to Mandarin Orange
At layer #25 (2.08mm) swap to Ice Blue for the rest.