Spool Stabilizer
Copyright Claim
Spool Stabilizer
Boost
5
8
1
Print Profile(1)
0.8mm nozzle, 0.56mm layer, 1 walls, 15% infill
Designer
29 min
1 plate
Open in Bambu Studio
Boost
5
8
1
1
7
4
Released
Description
This quick print allows to stabilize undersized spools on the dispenser. I printed it with a 0.8 nozzle at draft definition and it's doing a great job.
Make sure that the fins are printed in at least 2 walls.
Comment & Rating (1)
All
Print Profile
0.8mm nozzle, 0.56mm layer, 1 walls, 15% infill
Printed in Hatchbox gray PLA, turned out perfect. Unfortunately, the inner circle is a little too small to fit on my (re-released) A1. I'll try scaling it up a bit to see if I can slip it over the end cap on the arm of the spool holder.
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld