ID Badge Holder
ID Badge Holder
Boost
34
77
24
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
1.3 h
1 plate
Boost
34
77
24
0
216
183
Released
Description
Needed an ID bagde holder that can carry a few extra namecards for emergencies. Designed simply out of necessity as i could not find any online that was fit for my needs. Hope you all enjoy it. looking forward to comments for further improvement and upgrades.
Comment & Rating (24)
All
Used SUNLU PLA+. Had an issue with it sagging towards the top. Might try again with an adjustment or 2. This one still functions just fine and have it to a coworker that loved it
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
tried to slice to an A1 mini. attempted a couple times and it kept messing up :(
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
print came out good, but back card holder could use a simple clip to hold cards in
0
Reply
only 1 print make it successfully out of 5. good design but cant find a good orientation it get it printed out nicely.
added support in the middle section to have it straight. But still print out fails more than success.
The back opening would a cross make sense so for easy to push the ID card as well as name card.
(Edited)0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed super easy and it’s great for my badges!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
broke as soon as I took it off the plate. assuming it was an issue my end with filerment not the design.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Strength Issue
Support Issue
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution
© 2024 MakerWorld