Cartoon Wireless Mouse use hardware kit 002 Mickey
Cartoon Wireless Mouse use hardware kit 002 Mickey
Print Profile(1)
Description
Cute Cartoon Wireless Mouse (uses Bambu Labs Wireless Mouse Kit)
Everything fits on one build plate, including the A1 Mini. Please follow the instructions below to assemble your mouse.
| Step 1: Carefully remove supports from the top piece and the base. To remove the supports from the base holes please use a thin piece of metal such as a bent paperclip. |  |
| Step 2: Insert lens and on/off switch into the base. Please be careful to orientate correctly. Please note the position of the on/off switch. Make sure you slide it all the way to the right. Also, make sure it is firmly but gently seated into its slot. | 
 |
| Step 3: Insert the scroll wheel into its place on the circuit board. |  |
| Step 4: Make sure the on/off switch on the circuit board is moved fully to the left when looking at the bottom of the board. |  |
| Step 5: Fit the circuit board into the base. Gently press it firmly into the base. Make sure it is fully seated ino the bottom of the board. This is essential for proper operation of the on/off switch. |  |
| Step 6: Insert the electrical connectors as shown and plug into the circuit board. Please make sure they are fully seated into the connector. Please route the red wire as shown to prevent it from getting pinched. Optionally, to ensure the connectors stay in place you can place a drop of CA glue between the metal connector and the slot (be sure to give it a few minutes to dry before proceeding if you use glue). |  |
Step 7: Please press on the left and right mouse buttons and the dpi switch to make sure they are moving. Sometimes during the print the left and right button may be tight and require some gently prodding to release and move correctly. They need very slight movement to function, so do not press hard on them.
Insert a drop of CA or other glue into the two holes and insert the Mouse hands. You can put them in any orientation you want. It is your mouse, do as you please. Please allow a few minutes for the glue to properly set before continuing assembling your mouse. |  |
| Step 8: Press the top piece with the mouse ears into the corresponding place on the mouse body. |  |
| Step 9: Place the top of the mouse onto the bottom plate that has the electronics already installed. |  |
Step 10: Carefully turn the mouse over, holding it firmly together, and affix the top pieces to the base using four included screws. Use the small hex wrench that came with your printer to install the screws. The screws should be flush with the bottom of the base. Please avoid overtightening so that you do not strip the plastic where the screws are self-threading into.
Then, attach the adhesive feet to the base of the mouse. |  |
Step 11: Install a “AA” battery into the battery compartment. Then put the battery compartment cover into place. Ensure that the latch is flush with the bottom of the mouse base.
You are done! Turn on your mouse, use the included dongle with your computer, tablet, etc. and enjoy your mouse. |   |
Thank you for printing my cartoon wireless mouse. I hope you enjoy it! Five star ratings are greatly appreciated.
Comment & Rating (0)
License
