一款使用于A1mini这种尺寸不足以一次性打印整个支架的机器的悬挂平板支架

位置刚好不会挡住所有传感器和充电接口

共由三个打印件组成（需要另外将零件1另外镜像打印一份），中间通过M2.5的平头螺丝(8mm以上都能用)和自锁螺母固定，已经做了对应的沉头孔

背后支架是适配标准1/4英寸螺丝的固定孔，能够轻松装上任何魔术手支架:)

A hanging flat stand for a machine like the A1mini that is not large enough to print the entire bracket at once

The position is just right not to block all the sensors and charging ports

It is composed of three prints (part 1 needs to be mirrored to print another part), and the middle is fixed by M2.5 grub screws (8mm or higher can be use)and self-locking nuts, and the corresponding counterbore has been made

The back bracket is a fixing hole that fits standard 1/4" screws, making it easy to fit any magic hand bracket :)

商城没有同款螺丝，所以找了尺寸基本符合要求的（应该也能用？）

There is no screw of the same type in the official mall, so I found a size that basically meets the requirements (should it also be usable?)