please read all of the information below before printing.

FYI - Profile indicates 5hrs print time…that's for all of the option plates. If you print the tall version with the logo the actual print time is 1hr 13min. The short version with no logo takes 41min. 

This is my versions of a hygrometer stand/holder. I've created various versions included in the print file for either AMS or desktop use. The AMS version stands up straight and slips out of the AMS easily when a battery change is necessary. The desktop version is angled back a bit for stability and includes a tall and short version. Either AMS or Desktop version includes a Bambu logo or logo-less option. For those wanting the logo option I've included a plate for a standard print quality logo, quite adequate for in the AMS or a higher quality for the desktop version.

I've experimented with the settings and suggest you leave them as assigned with one exception… There is a test plate for the hole diameter of the hole the hydrometer will friction fit into. I suggest you print the test plate first. You'll see I've set the hole XY compensation to -0.1 for each stand including the test plate. If you print the test plate and your hygrometer fits loose adjust the XY compensation found in the quality setting further in the negative. If it too tight move the XY comp in the positive direction.

The Bambu logo is printed separately and later super-glued in place to reduce printing time. It actually fits firm enough to not need glue but I'd suggest you glue it as soon after print as possible as PLA shrinks and swells with moisture and temperature.