Owl Hueforge AMS

Print settings:

• Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
• Nozzle: 0.4mm

Filaments Used:

• PLA Matte Black
• PLA Matte Gray
• PLA Matte White

This print uses 3 unique filaments

Swap Instructions:

• Start with Black
• At layer #10 (0.88mm) swap to Gray
• At layer #14 (1.2mm) swap to White for the rest

*IMPORTANT INFORMATION*

• You cannot adjust the z scaling on any hueforge. This will mess with the coloring done and your hueforge will not come out as intended. You can however change the x and y to scale the picture. I recommend only changing by the same percentage.

• To get an accurate print as shown in the photos you MUST use the same filaments listed below. You can change brands (as long as they are similar) but keep the filament colors the same. If you use any other color, you will not get the same results as me.

• What you see in the slicer will not be how the final results will look! Hueforge takes advantage of color bleed to make the blended colors!

* This image was generated with Adobe Firefly *