Gen 3 M18 FIVE BIT Holder
Copyright Claim
Gen 3 M18 FIVE BIT Holder
Boost
16
31
2
GIF
Print Profile(4)
* ABS * 0.16mm layer, 2 walls, 100% infill
Designer
59 min
1 plate
* PLA *0.16mm layer, 2 walls, 100% infill
Designer
52 min
1 plate
* PLA * LEFT HANDED * 0.16mm layer, 2 walls, 100% infill
Designer
52 min
1 plate
* ABS * LEFT HANDED * 0.16mm layer, 2 walls, 100% infill
Designer
59 min
1 plate
Open in Bambu Studio
Boost
16
31
2
0
11
9
Released
Description
M18 Gen 3 FIVE BIT Holder
8x3 MM Magnets required
Glue required (gorilla glue worked great)
2.5x 6 mm screw required
Five Bit holder that can support up to 3 nut drivers, up to 1 stubby bit and up to 4 full shank bits.
Comment & Rating (2)
All
Print Profile
* ABS * 0.16mm layer, 2 walls, 100% infill
printed with no issues in ABS, I put the magnets on the end of the bits and then a drop of glue on the other end. This made it quite easy to glue the magnets in place as I just slid the bit into the hole and pushed the magnet into place
The designer has replied
0
Reply
thanks 😊
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld