Made with Overture TPU in black, this 12 ounce can koozie was designed to utilize Cura's infill settings to create double-wall insulation to prevent sweating and to keep drinks cold. It feels and is squishy just like a foam koozie and has a hole on the bottom to allow air to escape while inserting and removing the can. It is a very snug fit and will not fall off during use.

As for all my prints, I am using an Ender 3 Pro with a 0.4mm nozzle and upgraded boden tubing, springs, and a Creality glass print bed. I used Cura 5.4 software and the following settings to slice this model.

Print Settings:

• Layer Height: 0.2mm
• Nozzle Temperature: 225°C
• Bed Temperature: 50°C
• Initial Layer Speed: 10mm/s
• Print Speed: 30 mm/s
• Retraction: Disabled
• Print Bed Adhesion: None
• Infill: 20%

Please reach out with questions and leave a comment down below if you try this out for yourself!