BEAR

Boost
4
3
0

Print Profile(1)

All
A1 mini
P1S
P1P
X1
X1 Carbon
X1E
A1

0.08mm layer, 2 walls, 100% infill
0.08mm layer, 2 walls, 100% infill
Designer
3 h
1 plate

Boost
4
3
0
0
2
0
Released

Description

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 113.33x170mm in size
You may print at higher layer heights below the Min Depth of 0.72mm
The Max Depth is 2.9mm and the Actual Depth is 2.4mm

Filaments Used:
PLA smartfil negro Transmission Distance: 0.4
PLA smartfil gris Transmission Distance: 0.8
PLA smatfil White Transmission Distance: 6
PLA smartfil marron Transmission Distance: 5
PLA smatfil naranja Transmission Distance: 1.2
PLA smatfil amarillo Transmission Distance: 5.8
This print uses 6 unique filaments

Swap Instructions:
Start with negro
At layer #10 (0.88mm) swap to gris
At layer #11 (0.96mm) swap to White
At layer #21 (1.76mm) swap to marron
At layer #24 (2mm) swap to naranja
At layer #25 (2.08mm) swap to amarillo

This slider is set higher than the mesh depth. It is not affecting your final mesh. Consider removing it.
At layer #28 (2.32mm) swap to negro for the rest.

Comment & Rating (0)

Please fill in your opinion
(0/5000)

No more