Search models, users, collections, and posts
Rock Float
IP Report
Print Profile(0)
Add the first print profile to earn points
Boost
13
20
0
1
11
3
Released
Description
Simple floater, print upper half on 0,12mm layer, other parts can be printed on standard 0,2 layer.The pin at the bottom can be replaced with a piece of filament and a rubber band to hold the line. I added printable connector to connect main parts, but it's still best to use glue.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)