Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size. You can adjust the X and Y to your preference but Z must remain the same.
You may print at higher layer heights below the Min Depth of 0.48mm
Actual Depth is 2.2mm

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Blue Transmission Distance: 4
PLA BambuLab Basic Red Transmission Distance: 4
PLA BambuLab Basic Jade White Transmission Distance: 5
This print uses 4 unique filaments. Substitute as you see fit.

Swap Instructions:
Start with Black
At layer #8 (0.72mm) swap to Blue
At layer #14 (1.2mm) swap to Red
At layer #22 (1.84mm) swap to Jade White for the rest.