The lightbox is created meticulously to reflect Olympiacos, a club with a great past and fans who are passionately in love with it. Designed intricately through 3D modeling, it embodies all aspects that make the OSFP trademark logo outstanding, hence giving an impression of an organization that has been in existence for long periods and whose pride is known all over. Within the lightbox, a play between darkness and brightness brings out a 3D appearance which evolves into different versions as one observes it.

The Olympiacos lightbox apart from adding to the beauty serves as a sign of creation since it marries old school artisanship with current technological strides. At home, in the office or any other place dedicated to a fan base, the Olympiacos lightbox is used to show how its owners have given all their minds to their job and care about the club.

Warning

• If you don't have LEDs or prefer not to install them, you can simply glue the parts together to create an impressive sign!

Materials & Tools:

• Glue Gun
• Aluminum Tape
• 1m USB LED Strip Lights, DC 5V 2835 White(the one I use)

Recommendations before and after printing:

• Textured PEI sheet
• Use the print profile, it has a few setting changes that helps you achieve the best results
• If you don't want to use a USB strip you just remove the cube from the backplate
• Use the aluminum tape on the inside of the backplate, it helps a lot with the light diffusion
• Placing the Leds in 2 circles but not too close from each other, otherwise it will ruins the diffusion
• Glue the Leds every 10cm distance for better hear adhesion

Bambu Studio Settings:

The related print profile has some settings that gives you the best possible results.

Bambu Studio Settings:
If you decide not to use the related profile, here are some settings that I recommend:

• Activate developer settings from Preferences
• Quality→Advanced→Initial Layer Flor Ratio:1.04
• Quality→Wall Generation→Arachne
• Quality → Wall Transitioning Threshold Angle → 50º
• Strength → Advanced → Infill/Wall overlap → 20%
• Quality → Advanced → Avoid Crossing Walls
• Increasing retraction until 1.2mm
• Color Printing Order from Lightest to Darkest Color