Hi everyone. I wanted to buy lamp for my daily painting miniatures. Unfortunately it was out of stock so I decided to do my own. Construction is not difficult, because my 3D lamp is done from:
- 5 pieces of curved part
- 1 piece of base holed
- 1 piece of mirrored base holed (you mirror in your slicer)
- 1 piece of holed connector
- 5 pieces of normal connector

NOTE: there is one more basic base (Lamp_partModular_Base) which has no rounded hole and also assemble hole has different location. Please, be careful before you select parts, which you wanna print.

Because of print quality I recommend to use sandpaper and make surface of connector smooth before you plug them inside the main parts.

LED strip lenth is around 80cm totally sufficient. Please, use the Base holed part to put strip thru the hole and than assemble it with rest of components as last part.

You can also print your controller holder and glue it on one of sides, where you like it more.

This is only the first version of lamp. I expect some advanced in future and also reflect the improvements, which you recommend to me.