A little clock designed to use with the Bambu Clock Components Kit 011.

• To customize the pattern, open the print profile on your computer, and change the Sparse infill pattern and Sparse infill density to whatever you like the look of. The pictures display Cross Hatch, Archimedean Chords and Honeycomb all at 15% density.
• Once printed, remove the small amount of support material. Use the small spacer and nut to secure the hardware to the print, press the clock hands onto the shaft, and the seconds hand into the pin that you will need to pop off the seconds hand in the kit; before securing that into the assembly.
• For the seconds hand to work freely, you need to ensure that it does not rub at all on the minute hand. This clearance has been considered in the design, but you may need to ensure each part is pressed on correctly.

Self-slicing guidelines:

• If you're slicing the files yourself, make sure you set at least 5 wall loops, the bottom layers to 0 and have the clock face down on the build plate. It is also important to activate supports, as a small section requires them.